Periodically clean the mat.
Cleaning scan and cut mats.
Using a baby wipe wipe over the cutting area to remove all the fluff lint hair and whatever else is sticking to that mat.
In this brother scan and cut tutorial you will learn how to clean and maintain your scanncut.
This is a really easy process and basically consists of removing the old glue and putting the 2 way zig glue on.
Run the mat under lukewarm water.
My personal preference is using a zig two way glue pen or click here jumbo size works best scribble the.
Work on a section at a time and ensure that you do not get it over the edge.
You may need to use a bit of pressure here.
Once all the other fixes no longer work then it is time to head to the zig glue and restick your scan n cut mat.
Cricut remends not scraping as it may bury the debris into your mat making them harder to remove.
First try wiping your mat down with a baby wipe.
You will learn tips and tricks for cleaning and maintaining the brother scan and cut sdx125 and the scanncut 2 or cm350.
How to clean your scanncut mat.
This is pretty much all you need to do.
The glue goes on blue and dries clear.
Ways to re stick your brother scanncut mat.
In this brother scan n cut tutorial we show you how to clean your ma.
This video is filled with tips on ways to maintain your scanncut mats.
Don t get concerned if your brother scan n cut mat looks dirty and loses its stickiness.
How to retack or restick your scanncut mat.
Using the included spatula lightly scrape off any cuttings attached to the mat.
Use a plastic hard bristled brush to gently scrub the mat in a circular motion.
Cuttings and cut edges of patterns attached to the mat may reduce the mat s adhesive strength and prevent correct operation.
You may also place the water in a nearby bowl.
Use paper towel to start wiping off the old glue.
This will not only clean the mat but will reactivate some of the stickiness.
If you don t have baby wipes on hand then washing your mat with warm soapy water and a cloth should work fine too.
Slowly place the sheet onto the mat working from top to bottom smoothing out any air bubbles along the way.
Keep a file journal.
Apply the goo dissolver onto the mat.
The concepts apply to any model of scanncut you own.
